Avaya CallPilot 703t, Установка оборудования, Страница: 36 / 52

Note:
The DS30X cable that connects the MPB96 boards to the MGate cards is 20 m
(60 feet) long. This allows the server to be placed in a different room from the
Meridian 1 switch or Avaya CS 1000 system.
2. Connect peripheral devices as described in the remainder of this chapter.
Preparing the modem
You require a modem to support remote dial-up access to the Avaya CallPilot
®
server. The
modem also enables Avaya technical support to connect to your Avaya CallPilot server for
troubleshooting purposes. Avaya connects to your server only when you request technical
assistance.
Required equipment
To install the modem, you need the following equipment:
• an analog external modem that includes
- an RJ-11 analog phone cord
- a power adapter cord
- US Robotics 56 Kbps modem (NTRH9078) (North America only)
- a 25-pin male to 9-pin female shielded serial cable for your modem (A0841984)
• an analog line jack
• tweezers, or a screwdriver small enough to use to adjust DIP switches
Modem DIP switches
Set the modem DIP switches before you connect the modem to the CallPilot server.
Note:
This section applies only to the US Robotics 56 Kbps external Sportster modem. If your
modem is different, refer to the documentation for your modem.
The following diagram shows the key components of the external modem, including the
location and required settings of the DIP switches:
Installing the server and connecting the peripheral devices
36 Avaya CallPilot® 703t Server Hardware Installation December 2010