Avaya 3641, Установка, настройка и администрирование

Страница: 62 / 150

Part B: Avaya 3641/3645 Wireless IP Telephone
62 Avaya Voice Priority Processor, Avaya 3641/3645 Wireless IP Telephone, Handset Administration Tool
DHCP option 151, then a DNS lookup of “SLNKSVP2” if the DHCP options 6 (DNS
Server) and 15 (Domain Name) are configured.
OAI Server IP
– the IP address of the NL OAI Gateway. If using static IP configuration,
this is simply the IP address of the NL OAI Gateway. If DHCP is being used, the
Wireless IP Telephone will try the DHCP option 152.
SSID
Enter the SSID.
WLAN Settings
Select between Custom and CCX modes. The Custom mode allows explicit control of all
of the Security and QoS settings. Using CCX mode automatically enables the CCXv4
features and functions, The CCX setting defaults the phone’s operating mode to be
compatible with Cisco’s CCX V4 (Cisco Compatible Extensions) requirements, with only
the 802.1X mechanism needing to be selected.
Custom-Security
 Handset security setting should match exactly the settings in your WLAN. Consult
the
VIEW Configuration Guide for the APs installed in your facility for information
on which of the security WPA versions methods are certified.
 Encryption codes display as they are entered. For security reasons codes will not
display when a user returns to the Admin menu, Encryption options.
*
NONE
disables any 802.11 encryption or security authentication mechanisms.
WEP
(Wired Equivalent Privacy) is a wireless encryption protocol that encrypts data frames
on the wireless medium allowing for greater security in the wireless network. If WEP is
required at this site, you must configure each Wireless IP Telephone to correspond with
the encryption protocol set up in the access points. Select the entries from the options
below to enable the Wireless IP Telephone to acquire the system.
Authentication
Select either Open System or Shared Key .
WEP [Enable/Disable]
Select either Enable WEP or Disable WEP .
Key Information
Default Key
– Enter the key number specified for use by the Wireless IP
Telephones. This will be 1 through 4.
Key Length
– Select either 40-bit or 128-bit depending on the key length specified
for use at this location.
Key 1-4
– Scroll to the key option that corresponds to the Default Key that was
entered above. Enter the encryption key as a sequence of hexadecimal characters.
(Use the 2 and 3 keys to access hexadecimal digits A-F, use the Right Arrow key
to advance to the next digit, and the Left Arrow key to backspace.) For 40-bit keys
you will need to enter 10 digits; for 128-bit keys you will need to enter 26 digits.
The display will scroll as needed.
Rotation Secret
– This is used for proprietary WEP key rotation. Refer to your custom
document if this feature is supported in your system.