Configure H.323 video endpoints on Communication Manager 6.0
AVTS R 6.0 Quick Setup
For feedback, use [email protected]
August 2010
17
Configuring Polycom RMX Series Video Conferencing Bridge
Platform
Use this procedure to configure the Polycom RMX series video conferencing Bridge platform.
Table 8: Configuring Polycom RMX Series Video conferencing on Bridge Platform
1.
Enter
change node-names ip
to add an entry for the RMX system. Be sure to enter
the IP address of the IP board for the RMX system.
2
Enter
add trunk-group
to add a two-way trunk group for the RMX system. Set the
following parameters:
●
Group Type:
ISDN
●
Direction:
Two-way
●
Carrier Medium:
H.323
●
Service Type:
Tie
3
Enter
add signaling-group
to add a signaling group for the RMX system. Set the
following parameters:
●
Group Type:
H.323
●
IP Video:
y
●
Priority Video. If you want all incoming calls to receive priority video
transmissions:
y
●
Trunk Group for Channel Selection to the two-way trunk group you added.
●
Near-end Node Name.
PROCR
may be used for all systems and
CLAN
may be
used for systems with port networks.
●
Near-end Listen Port:
1720
●
LRQ Required:
n
●
RRQ Required:
y
●
Enable Layer 3 Test:
n
●
Far-end Node Name to the name you entered for the RMX system
●
Far-end Listen Port:
1720
●
Far-end Network Region
●
Calls Share IP Signaling Connection:
n
●
Direct IP-IP Audio Connections:
y
●
IP Audio Hairpinning:
n