EQUIPMENT MAT
LEVELING:
Turn the dials in the
LEVELING CAPS(50)
which are attached to the
REAR STABILIZER(3)
so that the
AVARI® Programmable Stepper
sits on the floor without rocking.
MOVING:
The
AVARI® Programmable Stepper
has a pair of
WHEELS(31)
on the front stabilizer
of the
MAIN FRAME(1).
Lift up the
REAR STABILIZER(3)
to move the
AVARI®
Programmable Stepper.
FUNCTION INSPECTION:
Visually inspect the
AVARI® Programmable Stepper
to verify that assembly is as shown in the above
illustration. Check the function of the
AVARI® Programmable Stepper
by stepping on the
PEDAL
CAPS(47)
slowly move through one complete cycle to verify that the drive train functions properly. Use
the
UP, DOWN,
and
ENTER
buttons on the
COMPUTER(71)
to select a program and verify that the
Magnetic System provides different tensions. Refer to the COMPUTER INSTRUCTIONS on pages 12 to
21.
CAUTION:
Locate and read the
WARNING LABEL(87)
on the
AVARI® Programmable Stepper.
Make
sure that all users read the
WARNING LABEL(87)
before using the product.
SET UP INSTRUCTIONS
11
Place the
AVARI® Programmable Stepper
in the area where it will be used. It is recommended that
the
AVARI® Programmable Stepper
be placed on an equipment mat. The operation dimensions of the
AVARI® Programmable Stepper
are approximately 38.8 inches long x 39 inches wide x 59 inches tall.
(These dimensions may vary up to one inch.) Make sure that adequate space is available for access to
passage around and emergency dismount from the
AVARI® Programmable Stepper.
A minimum of 20
inches on at least one side and 20 inches either behind or in front of the
AVARI® Programmable Stepper
is required for safe operation.
Front Stabilizer
Dial
Содержание A400-300
Страница 26: ...PRODUCT PARTS DRAWING 26 FRONT BACK...
Страница 29: ...NOTES 29...
