Avanti OCTOPUS XL120, Руководство пользователя

Страница: 14 / 36

3.2.3 Interior light
3.2.3.1 Service light
The service lift is optionaly equipped with a light
inside the cabin. When service lift is connected to
power supply, this light illuminates at all times.
3.2.3.2 Service light with emergency function
Optionaly the internal light is battery packed in order
to illuminate the inside of the cabin in case of a power
failure. When fully charged, it will last at least for 90
minutes.
3.2.4 Anchor points
The service lift features three anchor points inside the
cabin.
An additional anchor point is available to be used when
the user egress or ingress through bottom hatches.
Figure 7 : Anchor points
DANGER
The lower anchor point must only be used for
evacuation/rescue operation.
Fasten kit
M1 6 nut
3.3 Traction system
3.3.1 Traction hoist M 6 08
Avanti M 6 08 traction hoist is installed on the top ofthe
cabin. It is an electrical powered hoistthat powers the
service lift up and down along a traction wire
rope. It consists of a motor a gearbox and a traction
system.
3.3.1.1 Electromagnetic motor brake
The M 60 8 traction hoist is equipped with an
electromagnetic spring-loaded brake that engages
automatically when releasing the UP or DOWN
control buttons, or following a power failure. Manual
release of this electromagnetic motor brake is allowed in
the M 6 08 traction hoist. Once the electromagnetic
motor brake is released, the motor speed is controlled by a
centrifugal brake installed between the motor shaft
and the gearbox.
3.3.1.2 Overload detection device
An overload detection device is built into the
traction hoist. Incase of an overload, it will prevent the
upward travel of the service lift (by
interrupting control) and a buzzer will sound,
until overload condition is eliminated.
3.4 Fall arrest device
3.4.1 ASL 6 08 Fall arrest device
The service lift is equipped with the ASL 6 08 fall arrest
device which will be triggered in case of an overspeed
condition.
The speed of the safety wire rope passing through the
device is continuously monitored, and the jaws
automatically close in the event of sudden excessive
speed.
This device protects the service lift against traction
wire rope breakages or traction system failures.
The fall arrest device can also be engaged or
disengaged manually by acting directly on the fall
arrest device levers.
3.4.2 Shock absorber
The fall arrest device is equipped with a shock
absorber system.
Its function is to relieve the impact force on the cabin
by means of the shock absorber displacement in case
of the fall arrest device activation.
3.2.5 Internal emergency ladder
The service lift features an internal emergency ladder that
is part of the main frame of the service lift.
In case of emergency, this internal ladder allows users to
reach the top hatch and accesing to ladder and ladder
rail.
NOTICE
Optional f eature.
11
3.2.6 Fasten kit
The service lift features as option a special tool, called
Fasten kit, for mechanically blocking the lift in order to
perform installation/maintenance tasks below the
suspended cabin. This kit is located inside the cabin (see
Figure 8). It consists in two M16 screwed rods, that must
be inserted through the holes of the top and bottom rollers
assembly and along rungs of the guiding ladder, and finally
blocked each with a M16 nut.
WARNING
The internal emergency ladder cannot be used as
anchor point for user’s PPE’s
M1 6 screwed rod
Figure 8 : Fasten kit