Avantco Equipment 177CAG15MG, Руководство пользователя

Страница: 9 / 29

User Manual
www.AvantcoEquipment.com 9
COUNTERTOP MANUAL GAS GRIDDLE
For conversion the following guidelines should be followed:
1.
Close the manual gas valve and disconnect the product
from the gas network, making sure that there is no leakage.
Then remove the pressure regulator from the gas inlet on the
product to make work easier.
2.
Remove the manual gas griddle assembly (1) with the help of
two or more people. For this, extreme care must be taken, as
physical injuries or serious damage can occur.
3.
Remove the screws that secure the burners (2) to the rear
support with the aid of the double screwdriver. Afterwards,
remove the burners from the product.
4.
Remove the injectors (3) with a 1/2” wrench.
5.
In place of the removed gas injectors (3), place the new
injectors that are included with 4 the kit shipped with the
product. But first apply some pipe sealant to the valve thread
and then screw-in the new injectors to the correct gas type.
6.
Once the gas injectors (3) are changed, reassemble your
product (4).
6.
In place of the removed gas injectors (4), place the new injectors that are included with the kit shipped with
the product. But first apply some pipe sealant to the valve thread and then screw-in the new injectors to the
correct gas type.
7.
Remove the pilot burner nut (7) to change the injector orifice that is inside the nut. The orifice for the
exchange is included in the accessory kit.
8.
After changing the gas injectors, reassemble your product. Return the burners to their original
configuration, however, now with the new injectors.
9.
After repositioning the thermostat bulb inside the welded support at the bottom of the plate, fit the plate
assembly back into the product. Replace the panel and secure it with the screws that were removed earlier.
10.
The following image serves to help identify the components mentioned above.