Avantco Equipment 177CAG15MG, Руководство пользователя

Страница: 13 / 29

User Manual
www.AvantcoEquipment.com 13
COUNTERTOP GAS GRIDDLE, THERMOSTATIC
1. Open the manual gas supply valve (which will release gas
into the product).
2. Immerse in alcohol the lighter (wick) that accompanies
the product and light it. Note: Make sure that the container
where the alcohol is located is away from the product and
wick after immersing.
3. Press lightly and rotate the handle to the pilot position.
4. Keep it pressed and take the igniter (wick) passing
between the pilot flame ignition hole in the product panel
until it comes into contact with the pilot and ignites the
flame.
5. Keep the knob pressed for 10 seconds after the pilot
flame is lit and turn the knob counterclockwise until
the wished temperature (use the knob to adjust the
temperature).
6. Make sure the burner is lit. If the burner does not light,
repeat the procedure.
COUNTERTOP GAS GRIDDLE, MANUAL
1. Open the manual gas supply valve (which will release gas
into the product).
2. Immerse in alcohol the lighter (wick) that accompanies
the product and light it. Note: Make sure that the container
where the alcohol is located is away from the product and
wick after immersing.
3. Take the igniter (bypass) past the ignition hole in the
flame of the pilot on the product panel until contact with the
pilot burner and until the flame ignites, repeat this procedure
on all pilots (see following image). Note: The ignition order
does not interfere with the use of the equipment.
4. Turn the knob corresponding to the burner you wish to
operate counterclockwise (adjust the flame through the
knob).
5. Make sure the burner is lit. If the burner does not light,
repeat the procedure.
6. After lighting all burners, you can turn off the burners
and turn them back on simply by turning the corresponding
knobs. Note: The pilot burner flame is factory set
according to the gas for which the product was originally
manufactured. Always check through the hole identified on
the panel as PILOT, if the pilot burner flame is lit. If it is not,
perform the procedures described above again.