Avantco Equipment 177CAG15MG, Руководство пользователя

Страница: 14 / 29

User Manual
14 www.AvantcoEquipment.com
COUNTERTOP RADIANT GAS CHARBROILER
1. Open the manual gas supply valve (which will release gas
into the product).
2. Immerse in alcohol the lighter (wick) that accompanies
the product and light it. Note: Make sure that the container
where the alcohol is located is away from the product and
wick after immersing.
3. Bring the igniter (wick) through the pilot flame ignition
hole in the product panel until contact with the pilot burner
and until the flame ignites, repeat this procedure on all pilots
(see the following image).
4. Rotate the knob corresponding to the burner you wish to
operate, rotate 90° counterclockwise.
5. Make sure the burner is lit. If the burner does not light,
repeat the procedure.
6. After lighting all burners, you can turn off the burners
and turn them back on simply by turning the corresponding
knobs. Note: The pilot burner flame is factory set
according to the gas for which the product was originally
manufactured. Always check to see if the flame on the pilot
burner can be seen through the panel hole. If it is not lit,
perform the procedures described above again.
COUNTERTOP GAS HOT PLATE
1. Open the manual gas supply valve (which will release gas into the product).
2. Immerse in alcohol the lighter (wick) that accompanies the product and light it. Note: Make sure
that the container where the alcohol is located is away from the product and wick after immersing.
3. Bring the igniter (wick) until contact with the pilot burner until the flame ignites, repeat on all others.
(see image). Note: The ignition order does not interfere with the use of the equipment.
4. Turn the knob (BUTTON) corresponding to the
burner you wish to operate counterclockwise
(adjust the flame through the knob).
5. Make sure the burner is lit. If the burner
does not light, repeat the procedure.
Note: The pilot burner flame is factory set
according to the gas for which the product
was originally manufactured. Always check
that the pilot burner flame is lit. If it is not,
perform the procedures described above
again.