Avantco Equipment 177CAG15MG, Руководство пользователя

Страница: 12 / 29

User Manual
12 www.AvantcoEquipment.com
First-Time Use
Against shock damage or rocking from transportation, the sides and waste tray have a protective
PVC film. Remove any plastics, straps, or protective film from the product before operating the
equipment.
COUNTERTOP GAS GRIDDLE, THERMOSTATIC & MANUAL
To protect the equipment against possible moisture damage between fabrication and installation on
site, the flat-tops are coated with a layer of vegetable shortening and brown paper.
In addition, you should remove grease and brown paper, cleaning should be performed with the aid
of a sponge, mild soap and water in small amount.
After this procedure, turn the burners on and leave them on for about 15 minutes, this will cause all
flat-top grill residue to be burned and eliminated. Only then will the equipment be ready for use.
COUNTERTOP GAS RADIANT CHARBROILER
To protect the equipment against possible moisture damage between manufacture and installation
on site, the grills and baffle rails are coated with a layer of vegetable oil.
In addition, you should perform a cleaning with the help of a sponge, neutral soap, and water in small
amounts. After this procedure, turn the burners on and leave them on for about 15 minutes, this will
cause all gas charbroiler residue to be burned and eliminated.
Only then will the equipment be ready for use.
COUNTERTOP GAS RANGE
You should perform a cleaning with the help of a sponge, neutral soap, and water in small amounts.
Only then will the equipment be ready for use.
Product Ignition
If you need to adjust the pilot valves (one pilot valve corresponds to two burners) do the following:
1.
Turn the pilot adjusting screw counterclockwise, then light the pilot with the aid of the igniter
(wick) accompanying the product and adjust the flame to a height of approximately 0.5 cm;
2.
Turn on the gas valve by turning the knob counterclockwise to light the main burners;
3.
To shut down completely, close the gas valves by turning the knob clockwise and turn the pilot
adjusting screw clockwise to close the gas for the pilots.