AVANT A424013, Руководство оператора для насадки

Страница: 29 / 36

29 (36)
3 Alternatively, when the loader is equipped with the
optional Opticontrol
®
system, the attachment control
switch pack can be used to control the hatch
adjustment.
See page
16 for instructions about how to connect the
electric harness of the attachment.
The selection between the hatch and conveyor function
is controlled by switch number 1. Switch numbers 2 and
3 are not in use with the Silage dispenser.
4 Use the auxiliary hydraulics control lever to lift or lower
the hatch.
6.7 Transport position
CAUTION
Keep the loader stable. Always
transport the attachment as low and
close to the ground as possible.
Keep the telescopic boom retracted
during drive.
6.8 Working on uneven ground
Extra caution is needed when using the equipment on inclined terrains and slopes. Drive slowly especially on
inclined, uneven, or slippery surfaces, and avoid sudden changes in speed or direction. Operate the controls
of the loader with careful and smooth movements. Watch out for ditches, holes on the ground, and other
obstacles, as hitting an obstacle may cause the loader to tip over.
Maximum lifting capacity can not be achieved on inclined terrain. On horizontally tilted terrain the load must
not be lifted high. The loader frame articulation should be kept straight when lifting heavy loads; turning the
load during lifting operation will affect the stability of the loader and may lead to overturning of the machine.
6.9 Operation with a tilt adapter
The attachment is not intended to be used with a tilting adapter fitted in between the attachment and the quick
coupling plate of the loader. The attachment must be coupled directly to the quick coupling plate of the loader.
6.10 Storing the attachment
Uncouple and store the attachment on level ground. The best way to store the attachment is a place where it
is protected from direct sunlight, rain, and extreme temperatures.

Avoid leaving the attachment laying directly on the ground. Place it on blocks of wood or on a pallet, for
example.

Place the multiconnector on to its holder as indicated with an arrow in the figure below. Never leave the
hydraulic connector on the ground.

Make sure that the attachment is secured against all movements during storage.
Never climb on the attachment.
For longer storage periods touch up the paint where needed and grease the lubrication points in order to
prevent rust damage.