AVANT A21242, Руководство оператора для насадки

Страница: 11 / 22

11(12)
5. Assembly of the sand spreader
The sand spreader is ready for use as delivered. Attach the attachment and its hydraulic hoses to the loader
as instructed below.
If using the spreader as mounted to the back of the loader, refer to instructions about using the rear lift
device and rear auxiliary hydraulics outlet from the operator’s manual of the loader. The same overall
mounting procedure shown below must be followed.
5.1. Attaching the sand spreader to the loader
Mounting the attachment to the loader is quick and easy, but it must be done carefully. An attachment that
has not been locked may come off from the loader and cause hazardous situations. The attachment is
mounted to the loader boom by using the quick attach plate and the counterpart on the attachment. In the
worst case, the attachment may slide onto the driver along a raised boom. For this reason, the attachment
must under no circumstances be raised to a height of over one metre when it has not been locked. To
prevent hazardous situations, always follow the attachment mounting instructions provided in the following
pages. Also remember the safety instructions in Section 3 and the instructions provided in the operator’s
manual of the loader.
Step 1:
•
Lift the quick attach plate locking pin / locking pins up and turn them
backwards into the slot so that they are locked in the upper position.
•
If your loader is equipped with a hydraulic attachment locking system, see
additional instructions about the use of the locking system from the relevant
manuals.
•
Ensure that the hydraulic hoses are not in the way during installation.
Step 2:
•
Turn the quick attach plate hydraulically to an obliquely forward position
(manual tilt on rear lift device).
•
Drive the loader onto the attachment. If your loader is equipped with a
telescopic boom, you can utilise this. Align the upper pins of the loader’s quick
coupling plate so that they are under the corresponding brackets of the
attachment.
Step 3:
•
Lift the boom slightly – pull the boom control lever backward to raise the
attachment off the ground.
•
Turn the boom control lever left to turn the bottom section of the quick attach
plate onto the attachment (tilt rear lift plate manually).
•
Lock the locking pins manually or lock the hydraulic locking.
•
Always ensure positive locking of pins.