AVANT A21242, Руководство оператора для насадки

Страница: 7 / 22

7(12)
•
Pay attention to the surroundings and any other persons and machines moving in
the vicinity. Pay attention to the contours of the terrain as well as other hazards,
such as slippery surfaces, loose rocks, or branches and trees that could reach
the driver's area.
•
Make sure to use only an attachment that is in good operating condition. Perform
daily inspections and read the instructions regarding service and maintenance in
this manual. Never operate the attachment if the hydraulic systems of both the
attachment and the loader are not completely intact. Check the condition of the
spreader and mixing shafts regularly.
•
Do not remove the protective grille in the spreader or modify the attachment in
any other way that would affect its safety.
•
Make sure that the loader is equipped with necessary safety equipment, and that
they are in order. Seat belt must be used. If there are specific risks at the
operating area, appropriate safety equipment must be used. Wear a respirator
mask when handling dusty materials.
•
Also read the safety instructions of the loader from the operator’s manual of the
loader. Get familiar with the controls of the loader and how to drive it safely, and
also note the effects that slippery surfaces pose to the handling charasteristics of
the loader.
Familiarize youself with the controls and handling of the loader at a safe area. Pay
particular attention to safe stopping of the attachment and the loader. Keep in mind that
the weight of the spreader and slippery surfaces effet the manoeuvreability and
handling of the loader.
A running spreader or activated hydraulic circuit creates hazards of entanglement and
crushing near the spreader. Never try to reach the mixing or spreader shafts manually;
the remaining sand in the spreader must be mixed with suitable tools. Removing the
protective grille inside the spreader is allowed only when performing maintenance tasks
with the spreader hydraulically disconnected. The spreader must be stopped folloeing
the safe stopping procedure before going near it.
Safe stopping of the equipment, before going near the spreader
Always stop the spreader following safe stopping procedure before going near the
attachment. Safe stopping procedure prevents unintentional movements of the
spreader when filling or when clearing blockages. Never go under a raised loader
boom or the attachment. Note that the loader boom can move down even if the
engine of the loader is turned off. Safe stopping procedure:
•
Stop the attachment and the loader.
•
Lower the boom and the attachment on the ground.
•
Shut down the loader engine and lock the parking brake.
•
Release residual pressure from the hydraulic system.
•
Prevent starting of the machine, remove key from ignition.