4
Customer Supplied Base Plate
With Recommended Features
Per IGES Drawing
ADNS-6010 (sensor)
Customer Supplied PCB
ADNS-6120 (lens)*
Customer Supplied VCSEL PCB
ADNV-6340 (VCSEL)
ADNS-6230-001 (clip)
To Disassemble the ADNK-6013-SP01 Unit
The ADNK-6013-SP01 comprises of the plastic mouse
casing, printed circuit board (PCB), lens, buttons, and USB
cable. (See Figure 4.) Unscrewing the one screw located
at the base of the unit can open the ADNK-6013-SP01
unit. Lifting and pulling the PCB out of the base plate can
further disassemble the mouse unit.
Caution:
The lens is not permanently attached to the
sensor and will drop out of the assembly.
* Or ADNS-6130-001 for trim lens
Figure 4. Exploded view drawing of optical tracking engine with ADNS-6010 optical mouse sensor.
Dimension in millimeters / inches
Figure 5. Distance from lens reference plane to surface
Enabling the SROM
The ADNS-6010 must operate from the externally loaded
programming. This architecture enables immediate
adoption of new features and improved performance
algorithms. The external program is supplied by Avago
Technologies as a fi le which may be burned into a pro-
grammable device. A microcontroller with suffi
cient
memory may be used. On power-up and reset, the ADNS-
6010 program is downloaded into volatile memory using
the burst-mode procedure described in the Synchronous
Serial Port section. The program size is 1986 x 8 bits.
For more information, please refer to the ADNS-6010
datasheet.
While reassembling the components, please make sure
that the Z height (Distance from lens reference plane to
surface) is valid. Refer to Figure 5.
Sensor
Sensor PCB
Lens
Surface
VCSEL PCB
VCSEL
VCSEL Clip
2.40
0.094
