AV123 x-cs, Руководство по использованию

Страница: 7 / 24

Page
x-sls 2-Way Towers
Woofer
• Curvelinear Treated Paper Cone Woofer
• Polymer Chassis for Reduced Baffle Resonance
• Proprietary Venting System for Voice Coil Cooling
• Mass Load Stability Chamber in Enclosure for
Enhanced Low End Response
Tweeter
• Treated Fabric Dome Diaphragm
• Three Layer Pole Piece Damping Treatment
• Ferrofluid Voice Coil Thermal Management
x-sls Frequency Response = 45Hz-20KHz, +/-3dB
x-mtm 2-Way D’Appolito Towers
Woofers
• Dual Curvelinear Treated Paper Cone Woofers
• Polymer Chassis for Reduced Baffle Resonance
• Proprietary Venting System for Voice Coil Cooling
Tweeter
• Treated Fabric Dome Diaphragm
• Three Layer Pole Piece Damping Treatment
• Ferrofluid Voice Coil Thermal Management
x-mtm Frequency Response = 40Hz-20KHz, +/-3dB
x-pls 3-Way D’Appolito Towers w/Powered Sub
Same features as the x-mtm Towers with an active 10” subwoofer/12” passive radiator
Subwoofer Amplifier
• 150 Watts RMS
• Speaker or Line Level Inputs
• Adjustable Gain
• Selectable 0 or 180° Phase Control
• Adjustable Active Crossover (40-150Hz)
• Signal Sensing Auto ON/Standby Mode
Subwoofer
• 10” High Excursion Woofer
• 12” Passive Radiator
• -3dB @26Hz
Turn the speaker over (upside down)
and locate the four screws that hold
the base to the speaker. Remove the
base and set aside. Use a standard
(flat head) screwdriver to pry out the
stopper. Fill with sand or a heavy,
dense material. Tap the stopper back
in with a rubber mallet or hammer.
Reinstall the base and turn the
speaker back over. Done!
x-sls Mass Load Chamber