AV123 x-cs, Руководство по использованию

Страница: 15 / 24

Page 1
Connections
For the best sound quality and signal transfer, AV123 recommends a minimum of 16
gauge high quality, multi stranded, oxygen free copper speaker cables. Speaker wiring
connections are accomplished through the 5-way binding posts.
Left/Right Connections
Connect the amplifier’s LEFT channel outputs to the positive and
negative input terminals of the LEFT x-ls/x-cs monitor or x-sls/x-
mtm/x-pls tower, being sure to observe correct polarity. Connect
the amplifier’s RIGHT channel outputs to the positive and negative
input terminals of the RIGHT speaker, again being sure to observe correct polarity. Refer
to your amplifier’s connection manual if you have a multi-channel home theater amplifier
or receiver to ensure the component is suitable for driving 8 Ohm per channel loads.
Center Channel Connections
Connect the amplifier’s CENTER channel outputs to the positive and
negative input terminals of the CENTER CHANNEL speaker (most
likely an x-ls or x-cs monitor). Be sure to observe correct polarity.
Refer to your amplifier’s or home theater receiver’s connection
manual to ensure the component is suitable for driving 8 Ohm per
channel loads or the center channel output. Also, you must make sure the preamplifier/
processor has been configured to enable the center channel output.
x-sub or x-pls Subwoofer Connections
Although there is technically no connection necessary to the driver itself (we’ve already
done that part) you do have to choose connections for the audio input to the x-sub
subwoofer. There are several ways in which to accomplish this:
Speaker Level Inputs
In situations where a line level out from your receiver or pre-amp is
not available, we recommend the following method for connecting
the x-sub or x-pls:
1) Connect the monitor or tower speakers directly to the amplifier
outputs (both left and right channels).
2) Next, connect a second pair of speaker wires from each monitor to
the high level input on the x-sub or x-pls.
The high level input allows speaker level signals for signal input
and sums the left and right channels to a mixed mono input so the
sub remains active whether balance is moved from left to right. By directly wiring the
montiors or towers to the amplifier, the bottom octaves blend smoother with the output.
To
Amplifier
Positive
To
Amplifier
Negative
To
Amplifier
Positive
To
Amplifier
Negative
From left and right channel
monitor or tower speakers
Not Used