Set the Display Units (SAE/Metric)
The EZ-SCAN scanner can be set up to display in SAE
or Metric units. The default setting is SAE. Go to
Section 4 if you do not need to change the display units.
1. To change the unit of measure, press
CONFIG
from the initial
screen.
2. Use the arrow keys until
2-System Config
is
displayed, then press
ENTER
.
3. Use the arrow keys to select
1-SAE/Metric
, then press
ENTER
.
4. Use the
t
and
u
arrow keys to select
1-SAE
or
2-METRIC
then press
ENTER
to select the highlighted choice (or press the
CONFIG
Key to Cancel and return to the initial screen).
Adjust the Display Contrast and Backlight
The contrast on your EZ-SCAN scanner can be adjusted for easier
Viewing under different lighting conditions. Note, if scanner is left
in direct sunlight the Display can turn completely black. Should this
happen, put the scanner in a cool dark place for approx. 10 to 15
minutes. The display should return to normal.
1. To adjust the contrast of the screen press CONFIG key.
2. Use the arrow keys until 2-System Config is displayed, then
press ENTER.
3. Use the arrow keys until 3-Contrast Adjust is displayed, then
press ENTER.
4. Use the
t
and
u
arrow keys to adjust desired screen contrast
S
ETUP
/ O
PERATING
I
NSTRUCTIONS
(C
ONT
.)
Page 10
Содержание EX-SCAN 5000
Страница 1: ...USERS MANUAL...
Страница 95: ...NOTES Page 95...
Страница 96: ...NOTES Page 96...
Страница 97: ...NOTES Page 97...