DO…. Press all Function Switches gently
and treat system with respect.
DO…. Use the correct mouthpieces, refer
to user guide
DO…. Use a clean and hygienically
wrapped new mouthpiece for
every new user.
DO…. Ensure user blows through the
lipped end of the mouthpiece.
DO…. Ensure the system is calibrated
periodically as per manufacturer’s
recommendation.
DO…. Read this handbook and comply
with all instructions contained
herein.
DO… Have the system regularly
checked
DO…. Have your system serviced and
calibrated by a qualified and
approved Alcolock service
provider
DO NOT…. Perform a breath test if you have been
either drinking in the last twenty minutes,
or smoking in the last two minutes.
DO NOT…. Clean the case with chemical or
abrasive products, since these could
cause permanent damage.
DO NOT…. Allow the sampling port to become
blocked.
DO NOT…. Block or restrict the mouthpiece outlet
for example with your finger when
providing a breath sample. This may
cause serious damage.
DO NOT…. Consume alcohol and immediately blow
into the system.
DO NOT…. Eat any food and immediately blow
into the system.
DO NOT…. Blow smoke into the unit.
DO NOT…. Drink cold or hot water and then
immediately blow into the system.
DO NOT…. Use mouth fresheners or similar type
products which are alcohol based
prior to providing a breath sample.
DO NOT…. Open the instrument or attempt any
repairs, as this invalidates the systems
warranty.
DO NOT…. Leave the mouthpiece in the in the unit
when leaving the vehicle stationed for
long periods.
DO NOT… Deviate from the operators instructions.
ALCOLOCKS DO’S AND DON’TS
DO’S
DON’TS
IMPORTANT - EXCESSIVE ALCOHOL
Please note that in the case where excessive alcohol has been consumed,
if a breath sample is presented to the system, the device may take some time to recover
from the excessive alcohol presented to the sensor.
IMPORTANT - ALTITUDE
WARNING for altitudes greater than 2500 m
the unit is more sensitive to ethanol, and an
attempt to give a breath sample could result in
a FAIL even when the BrAC is lower than the
alcohol set point of the unit.
The VBS will then block the vehicle from
starting and the vehicle will not start.
6
WEEE Directive
Do not throw away or dispose of in landfill
site.
Return to local distributor or manufacturer.
PFK ELECTRONICS (PTY) LTD.
488 Umbilo Road, Durban 4001
Kwazulu Natal, South Africa
Tel : 27 31 274 7200
7
Federal Communications C ommission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s
authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
Thes e limits are designed to provide reasonable protection against harmful interference in a res idential installation. This equipment
generates, us es and can radiate radio frequency energy and, if not installed and used in accordance with the instructions , may caus e
harmful interferenc e to radio communications. However, there is no guarantee that interference will not occur in a particular ins tallation.
If this equipment does caus e harmful interference to radio or telev ision reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) this device may not c ause
harmful
interference and
2) this device must accept any interference
receiv ed
, including interference that may caus e undesired operation of the device.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End us ers must follow the s pecific
operating instructions for s atisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
