User Guide
P. 9
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are
OFF
. Leaving the headlight switch
ON
on certain types
of vehicles could cause them to remain
ON
even after remote starter shut down, resulting in a dead
battery.
Driving Off
With the vehicle running under remote control, press the
UNLOCK
button to disarm the security
system and unlock the doors. Enter the vehicle and do the following:
Turn the ignition key to the
IGNITION ON (RUN)
position. (
Do not turn the key
to the
CRANK
position
while the engine is running. This would cause the starter motor to re-engage.)
Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.
Using the Remote Starter
Arming and Disarming the Security System
To
disarm
the alarm and Starter Kill (if installed) and unlock the doors (if installed):
1. Press and hold the
UNLOCK
button for approx. 1 sec.
You will hear
two chirps
if the Siren or Horn is so configured.
2. The
UNLOCK
button will light up on the L.E.D. display of the remote control. The parking lights will
flash twice and the L.E.D. will go out to confirm that the doors have been unlocked and that the
starter kill (if installed) and the alarm are disarmed. Turning the ignition
ON
and
OFF
will reset the
alarm memory.
In Passive Mode, the System will rearm automatically 30 seconds after the key is out of the ignition
or was not turned to the ON position and the last door is closed. Remember that if the vehicle was
remote started, the break pedal must be pressed in order to allow the remote car starter / alarm to
detect that the user has taken over control of the vehicle and so to stop the sequence for passive
rearm.
To
arm
the alarm and Starter Kill (if installed) and lock the doors (if installed):
1. Press and hold the lock button for approx. 1 sec.
You will hear
one chirp
if the Siren or Horn is so configured.
2. The
LOCK
button will light up on the L.E.D. display of the remote control. The parking lights will
flash once and the L.E.D. will flash slowly to confirm that the doors have been locked and that the
Starter Kill feature (if installed) and the alarm are armed.
Idle Mode
Convenience feature:
Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running. For example, if you stop for a delivery or at a conveni-
ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.
Idle Mode can be activated through the same routine as that used for Ready Mode; at the last
step, the
TRUNK
button is pressed instead of the other buttons:
1.
Ensure that all the Doors are closed and that the Shifter is in the Neutral position.
2.
With the Engine already running, apply the Parking Brake and release the Brake Pedal.
Make sure to release the brake pedal.
3.
Within 20 sec. push
LOCK
,
UNLOCK
or
START/STOP
on the Transmitter.
The parking lights will flash 3 times quickly and remain lit.
4.
Remove the key: the Engine will go on running.
