Autostart AS-6460i TW-FM, Руководство пользователя

Страница: 17 / 17

User Guide
P. 17
Diagnostics – Parking Light Flash Table
Flashes Description
1
•
Doors locked, Alarm and starter kill armed.
•
Run time has expired.
•
TRUNK
button pressed.
•
Start signal received by the module.
•
Cold weather mode cancelled.
2
•
Remote start attempt cancelled by remote.
•
Doors unlocked, starter kill disarmed.
•
Exiting ignition valet
•
Exiting remote valet
•
Power-up reset.
3
•
Entering cold weather mode
•
Entering ignition valet
•
Entering or exiting Ready Mode
•
Entering remote valet.
•
Entering extended run time.
3 slow flashes… …after a failed start attempt The module did not detect a tach signal.
4
•
+12 V detected on the brake input wire either while cranking or during run time.
•
Entering multi-speed tach programming.
5 Slow
•
Start attempt failed because no tach signal has been programmed.
5 Fast
•
Tach signal programmed.
•
New transmitter programmed.
6
•
A remote start was attempted while a tach-before-crank signal was detected before cranking.
8
•
Unit reset
10
•
A ground (-) signal was detected on the hood pin input wire.
1 – pause – 2
• There was a remote start attempt while the vehicle was in valet mode.
•
Failed start: vehicle’s low battery voltage.
2 – pause – 2
•
There was an attempt to start the vehicle while the module was in valet mode.
…followed by 1 flash Exiting cold weather mode ON SOLID for 3
seconds….
…followed by 3 flashes Entering cold weather mode
ON continuously
•
Idle mode: Idle mode is engaged
•
Run time: The vehicle has been remote started and is in run time.
ON continuously While the brake pedal is pressed.
•
Confirms that cold weather mode is engaged
ON 2 seconds
•
The hood has been opened and a ground (-) signal has been detected on the hood pin input
wire.
ON 4 seconds • Locking or unlocking a door (with Door pulses configured to 4 sec.)
ON 20 seconds
•
The hood pin has been flashed and you now have access to the programming options.
ON 25 SEC.
•
The Hood Pin-switch has been pressed twice: the Unit went into step 1 of the Programming
Centre procedure, and no Transmitter activity was detected for 20 seconds.
•
Or the Unit went into step 1 of the Transmitter Programming procedure and no activity was
detected for a few seconds. The Unit has exited the Transmitter Programming procedure.
•
Panic Mode is activated.
CONSTANT FLASHES
UP TO 60 SEC.
•
In Siren or Horn Mode: Alarm condition generated by an intrusion, or when the System is
powered up.