Autonics MP-XGT, Техническое руководство по обслуживанию

Страница: 6 / 24

Safety Precautions
6 © Copyright Reserved Autonics Co., Ltd.
Safety Precautions

Following these safety precautions will ensure the safe and proper use of the product and
help prevent accidents, as well as minimizing possible hazards.

Safety precautions are categorized as Warnings and Cautions, as defined below:
Warning
Failure to follow the instructions may lead to a serious injury
or accident.
Caution
Failure to follow the instructions may lead to a minor injury or
accident.

In case of using this unit with machinery (E.g.: nuclear power control, medical equipment,
ship, vehicle, train, airplane, combustion apparatus, safety device, crime/disaster prevention
equipment, etc) which may cause damages to human life or property, it is required to install
fail-safe device.
It may cause a fire, human injury or property loss.

The unit must be installed on a device panel before use.
Failure to follow this instruction may result in electric shock.

Do not connect, repair, or inspect the unit while connected to a power source.
Failure to follow this instruction may result in electric shock.

Do not disassemble or modify the unit. Please contact us if necessary.
Failure to follow this instruction may result in electric shock or fire.

Check the terminal numbers before connecting the power source and measurement input.
Failure to follow this instruction may result in fire.

Do not use the unit outdoors.
Failure to follow this instruction may result in electric shock or shortening the life cycle of the
unit.

When connecting the power input or measuring input, make sure to tighten the terminal
screw bolt above 0.74N•m to 0.90N•m.
Contact failure may result in fire.

Use the unit within the rated specifications.
Failure to follow this instruction may result in electric shock or shortening the life cycle of the
unit.

Do not use loads beyond the rated switching capacity of the relay contact.
Failure to follow this instruction may result in insulation failure, contact failure, contact
bonding, relay damage, or fire.

Do not use water or oil-based detergent when cleaning the unit. Use dry cloth to clean the
unit.
Failure to follow these instructions may result in electric shock or fire.

Do not use the unit where flammable or explosive gas, humidity, direct sunlight, radiant heat,
vibration, and impact may be present.
Failure to follow this instruction may result in fire or explosion.