AutomationDirect DURAPULSE GS3-2010, Руководство пользователя

Страница: 66 / 316

Chapter 3: Keypad Operation and Quickstart
3–18
Write Parameter Settings to Drive
After the COPY KEYPAD parameter is enabled, the LCD display will show an
additional group called COPY KEYPD GROUP. Press the PROGRAM key and
then the UP/DOWN or PROGRAM keys until this new group is displayed.
Press the ENTER key to display the copy mode selections.
Select the WRITE TO DRIVE mode using the UP/DOWN keys.
Press the ENTER key to display the four (4) available program numbers to write
from the keypad to the AC drive. The program name must match the part number
of the AC drive being programmed; for example: GS3-2025.
Use the UP/DOWN keys to select the desired program number; PGM1 thru
PGM4 and press the ENTER key.
Use the UP/DOWN keys to select “Yes” to confirm and press the ENTER key.
The LCD display will show the message “Keypad => Drive, Loading...” while the
parameters are being copied and return to the program selection when finished.
RAMPS GROUP
P 1.00-P 1.22
MOTOR GROUP
P 0.00-P 0.07
COMMS GROUP
P 9.00-P 9.42
ENC FBACK GROUP
P10.00-P10.05
PROGRAM PROGRAM
COPY KEYPD GROUP
(ENTER)
WRITE TO DRIVE
1
Select Parameter Group
WRITE TO KEYPAD
3 Select Copy Mode
ENTER ENTER
WRITE TO DRIVE
PGM1: GS3-4040
WRITE TO DRIVE
PGM2: GS3-22P0
ENTER ENTER
5 Select Program to Write
ENTER ENTER
6
Are you sure?
8
WRITE TO DRIVE
PGM3: GS3-2025
WRITE TO DRIVE
PGM4: - Empty -
2
4
NO
Are you sure?
YES
7 Confirm Selection
Keypad => Drive
L o a d i n g . . .
ENTER ENTER
9
The "=>" & "Loading..." display
text flashes during copy keypad.
ENT
FWD/REV
RESET
RUN
JOG
DISPLAY
PROGRAM
STOP
FWD JOG STOP RUN REV
Risk of electrical shock. Wait 10 minutes after removing power before
Do not connect AC power to output terminals T1,T2 and T3.
WARNING
servicing.
POWER
ALARM
W
ARNING
: Do not remove the Keypad during transfer of program parameter settings
to or from the AC drive.
DURA
PULSE AC Drive User Manual 1st Ed. Rev. D 05/2013