19.5 - Setting the Transmitter to Operate Pet
(Pedestrian) Mode (Fig.32)
The opener can be programmed into a “Pet Mode” where
the door opens partially to allow pet to enter/exit the garage.
Press CODE SET button five times. The CODE SET LED
1.
will illuminate and the courtesy light will flash quickly
(twice per second) to indicate that the learning mode
for “Pet Mode” is active.
Choose a transmitter button that is not already coded
2.
into the receiver. Press this button for two seconds and
the CODE SET LED will begin to flash.
Press the same transmitter button again. The CODE SET
3.
LED will illuminate and then go out, and the courtesy
light will also switch off. This indicates that the code has
been stored.
19.6- To Erase Programmed Codes (Fig.33)
If the Code Set button is pressed and held on for 6 seconds,
the LED will blink rapidly for one second to indicate that all
programmed codes have been erased.
19.7 Installation of Wall Mounted
Transmitter (Fig.34)
IMPoRTANT WARNING: Locate the Wall
Mounted Transmitter:
Within sight of door.
•
At minimum height of 5 feet so shall
•
children are not able to reach it, and
Away from moving parts of the door.
•
To set the transmitter codes refer to
Step 19.1
.
Press Code set
Button five times
Select one of the
four buttons (not
programmed yet)
that you wish to
use to control the
door for “Pet Mode”
fig.32
fig.33
fig.34
Coding Transmitters
WARNING: The manufacturer is not
responsible for any radio or TV interference
caused by unauthorized modifications to
this equipment. Such modifications could
void the user’s authority to operate the
equipment.
Diamond PD
Power Drive
: Instruction Manual
© Copyright 2011
23
PA1000
Instruction Manual (Instructions d’installation)
