fig.38
How to Use Your Operator
For maximum efficiency of your operator, your garage door
must be in good operating condition.
An annual service of your garage door by an authorised
dealer is recommended.
CAuTIoN:
Activate the operator only when the
door is in full view, free of obstructions and
with the operator properly adjusted. No one
should enter or leave the garage while the door
is in motion. Do not allow children to play near
the door.
WARNING:
This opener is a mains voltage
plug in domestic appliance and there are no
user serviceable parts inside this operator.
Remote Control Transmitter
• To operate the garage door operator, press the
programmed button of the remote control transmitter
until your door begins to move (usually 2 seconds).
Make sure you can see the door when you use the
remote control transmitter.
• If you are in a vehicle you should aim the remote
control transmitter through your windscreen. If your
remote control transmitter has a visor clip, it should
be secured to the visor so that when the remote
control transmitter is operated it is transmitting
through the vehicle windscreen (
fig.38
).
• Check that the door is fully closed before you drive
away.
• If you press the remote control transmitter whilst the
door is moving the door will stop. The next press of
the transmitter will move the door in the opposite
direction.
The remote control transmitter may also be programmed to
operate the following features (see
pages 21
to
22
- Coding
Transmitter Features):
• to turn the courtesy light on and off without
operating the door,
• to activate the Auxiliary Output,
• to put the door into “Pet Mode” where it opens
partially to allow pet access to the garage, and/or
• to put the garage door operator into “Vacation Mode”
where it will not respond to any remote control
transmitters.
NoTE:
Additional remote control transmitters may be
purchased at any time.
PA1000
Instruction Manual (Instructions d’installation)
26
