Setting Speed and Limits
Step 17 - Setting Travel Limits
NoTE:
The door and shuttle must be engaged
into the chain/belt index. The door should be
open approximately half way.
Remove the controls cover (
fig.20
) to access the controls
panel and place it back when finish programming.
17.1 - Setting Limits Positions (
fig.21)
1. Press red Minus (
-
) Button and hold it, the door will start
closing. Release the button once when the door has reached
your desired closed limit position.
2. Press the limit set button. This action will store into
memory the closed limit position.
3. Press the green Plus (
+
) Button and hold it, the door will
start opening. Release the button once when the door has
reached your desired open limit position.
4. Read the
WARNING
below.
IMPoRTANT WARNING:
Please be aware that
the garage door will start closing automatically
once Step 4 is performed. The door will also
automatically re-open after fully closing with a
small pause between the cycles.
5. Press the Limit set button. This action will store into memory
the door limit position. The door will now automatically close
to its limit position then fully open to calculate the safety
obstruction forces.
Please be aware of the above warning.
The door operator can now be operated via the
oPERATE
button.
17.2 Resetting Door Limit Positions (Fig.22)
The door travel limit positions can be deleted for new
positions by the following steps below:
1. Press and hold Limit set button for six (6) seconds until
you hear three beeps and the red Close Limit LED starts
to flash.
2. Release the button.
3. Follow
Step 17.1
to set new travel limit positions.
fig.22
fig.21
IMPoRTANT NoTE:
The operate button will
not function until the open and close limits
positions are set.
PA1000
Instruction Manual (Instructions d’installation)
18
