Owner Installation Instructions
NeoSlider™ - Sliding Gate Opener NES-24V1
9
Drive Unit Installation
Mounting the Drive Unit
The NeoSlider™ mounting holes are slotted for fi ne adjustment of pinion gear and gate rack alignment. Follow
the procedure below to ensure fi nal adjustments can be made later.
We recommend that four 8mm (
5
/
16
”) or 10mm (
3
/
8
”) loxins and bolts are used to secure the Drive Unit into
position. These loxins usually require a 16mm (
5
/
8
”) masonry drill bit (if drilling concrete).
1. Prior to mounting the NeoSlider™, determine the distance from the gate to the outer edge of the rack (i.e. the
rack width) and to the datum line (see
Fig. 03
and
Fig. 04
). If using an Automatic Technology plastic rack, the
width is 40mm. If using a different brand of rack, please ensure it is Module 4 and then confi rm the width, as this
will vary.
2. Mark a line parallel to the face of the gate for the mounting holes. The distance from the gate is determined
by the formula (38mm + Rack Width). Therefore, if using an Automatic Technology rack, the distance is
78mm. Otherwise, if using a non-Automatic Technology rack, add your rack width (and spacers if required) to
the 38mm (see
Fig. 03
).
3. Another 100mm back, mark another line parallel to that described in point 2 for fi xing. (see
Fig. 03
).
4. Open the gate to the desired open position. Mark a line at a right angle to the gate 120-150mm from the
open edge of the gate for the mounting holes.
5. Then mark another line 268mm parallel to this line (see
Fig. 03
).
6. Place the Drive Unit in position where the lines intersect to check the mounting position. If satisfi ed with the
position, remove the Drive Unit.
7. Drill the four mounting holes where the lines intersect.
8. Hammer the loxins into position, place the NeoSlider™ and fi x with the four bolts. Remember when
tightening the bolts to allow fi ne adjustement of the NeoSlider™ later on.
03
fi g
Rack width
Gate
