18
NeoSlider™ - Sliding Gate Opener NES-24V1
Owner Installation Instructions
Note: The pedestrian default position is set
at fi ve (5) seconds from fully closed position
and can be changed as follows:
Step 1. Navigating to “set pedestrian menu”
1. Press PREV to navigate to Menu 10
(Fig. 14)
.
2. Press SET - MENU 10.1 is displayed.
3. Press NEXT to go to MENU 10.3.
4. Press SET to enter Set Pedestrian procedure.
Step 2. Setting pedestrian position
1. Press OPEN to change the pedestrian access position
time
(Fig. 15).
2. Press SET to record new time
Step 3. Pedestrian position set
The controller will return to the MAIN SCREEN with
the gate status shown as being in pedestrian access
mode
(Fig. 16).
Setting Pedestrian Position
MENU 10.3
Set Pedestrian
PR E S S
14
fi g
16
fi g
Ped’n Opening
Time
5
PR E S S
PR E S S
0 E D N ! C C E S S
0 R E S S
T O ! C C E S S
-% .53
15
fi g
Recalculate Force Margins
Reprofi ling is a simplifi ed way of re-learning the travel characteristic of a previously setup Limit Switch travel
installation. Re-profi ling can be used when the travel characteristics of the gate change due to mechanical
adjustments etc. To initiate a re-profi le simply locate “MENU 10.3 Reprofi le Travel” and press SET then
follow the prompts. The gate will start to move and re-calculate force margins. The gate can move between
the open and close limit positions up to two (2) times (depending on the position of the gate and the power
up condition).
A single beep will be heard once the process is complete and setup complete message will be displayed
a.
b.
Reprofi le Travel
