Owner Installation Instructions
GDO-9v2 SecuraLift®
21
Step 19.1 - Code a Transmitter Button for
Door Operation
Press and hold the DOOR CODE button
(Fig. 33)
.
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
Release the DOOR CODE BUTTON.
Press the transmitter button to test.
Step 19.2 - Coding a Transmitter Button to
the Courtesy Light
The transmitter can be programmed to operate the
courtesy light on the opener independently of the door
moving.
Press and hold LIGHT CODE button
(Fig. 34)
.
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
Release the LIGHT CODE button.
Press the transmitter button to test.
Step 19.3 - Code a Transmitter Button for Pet
(Pedestrian) Mode
Press and hold both the DOOR CODE and MINUS
(-) buttons
(Fig. 35).
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
Release the DOOR CODE and MINUS (-) buttons.
Press the transmitter button to test. To change the
default pet (pedestrian) door opening position,
refer Step 2.
Step 19.4 - Code a Transmitter Button to
Enable Vacation mode
The opener can be programmed into a “Vacation Mode”
where the opener will not respond to any transmitter
except one preprogrammed unit.
Press and hold LIGHT CODE and MINUS (-)
buttons
(Fig. 36).
Press one of the four buttons on the transmitter for
two (2) seconds, pause for two (2) seconds, then
press the same button again for two (2) seconds.
Release LIGHT CODE and MINUS (-) buttons.
To test, press and hold the transmitter button for
fi ve seconds to set Vacation Mode.
To reset Vacation Mode press the same button
for two seconds.
a.
b.
c.
d.
a.
b.
c.
d.
a.
b.
c.
d.
a.
b.
c.
d.
e.
Coding Transmitters
33
fi g
34
fi g
35
fi g
36
fi g
