26
ATS-3AM & ATS-2AM
Dominator Tempo & Syncro Instruction Manual
a. Switch power on and the BLUE LED on the CLOSE button
will
start to flash to indicate that the opener is ready to set the Close travel
limit
b. Press the MODE button repetitively until the TRANSMIT
LED is lit.
c. Press and HOLD the CLOSE button
to set the Open / Stop /
Close function. The Main light will start to flash rapidly.
d. Press and hold button 1 on the transmitter, then release transmitter
button.
e. Press and hold button 1 on the remote control button again until the
main light stops flashing rapidly.
f. Release both buttons. The transmitter button is now coded, press to
test and observe the speed of the door through a full cycle.
g. The drive speed is set to the fastest setting by default. This may not be
suitable for larger doors or for single piece doors:
E - Setting limits via Transmitter
Button 1
(inch Open)
Button 2 (Set)
Button 4
(inch Close)
CLOSE limit:
(i) Using the programmed transmitter, press and hold the button 4 to
close. To inch the door, single presses of the button 4 will move the
door to desired limit.
(ii) While inching (to CLOSE) to set the close speed, press
and hold button 4 on the remote and by pressing the
SET button 2 the opener will cycle through all three speed modes
as shown in table.
(iii) Once at the desired speed, release the remote button 4.
(iv) Continue inching the door to the desired position. We recommend
the CLOSE limit position being the first point of contact of the
rubber strip ( at the bottom of the door) with the ground.
(v) If the door overshoots, press the OPEN button 1 on the remote to
move the door in the OPEN direction.
(vi) When the door is at the desired CLOSE position, press the SET
button 2, the GREEN LED on the OPEN button
will now
flash.
WARNING! The door will automatically close, open and
close again after the next step. Ensure that nothing is
in the door’s path.
OPEN limit:
(i) Using the programmed transmitter, press and hold the button 1 to
open. To inch the door, single presses of the button 1 will move the
door to desired limit.
(ii) While inching (to OPEN) to set the open speed, press
and hold button 1 on the remote and by pressing the
SET button 2 the opener will cycle through all three speed
modes as shown in table.
(iii) Once at the desired speed, release the remote button 1.
(iv) Continue inching the door to the desired position. We
recommend the OPEN limit position being the height of the
garage opening
(v) If the door overshoots, press the CLOSE button 4 on the
remote to move the door in the CLOSE direction.
(vi) When the door is at the desired OPEN position, press the SET
button 2. The door will now automatically close and open to
calculate the safety obstruction settings.
