Diamond PD
Power Drive
: Instruction Manual
Dominator Tempo & Syncro Instruction Manual
ATS-3AM & ATS-2AM
15
© Copyright 2019
6.6 Coding Transmitters
Fig.6.6.1
TRANSMITTERS COMPLIANCE STATEMENT
TRANSMITTERS COMPLY WITH ALL UNITED STATES AND CANADIAN LEGAL REQUIREMENTS AS OF THE DATE OF
MANUFACTURE. TO COMPLY WITH
FCC PART 15
AND OR
RSS 210 INNOVATION, SCIENCE AND ECONOMIC
DEVELOPMENT CANADA
RULES, ADJUSTMENT OR MODIFICATIONS OF THIS RECEIVER AND / OR TRANSMITTER ARE
PROHIBITED, EXCEPT FOR CHANGING THE CODE SETTING OR REPLACING THE BATTERY. THERE ARE NO OTHER USER
SERVICEABLE PARTS. TESTED TO COMPLY WITH FCC STANDARD FOR HOME OR OFFICE USE. OPERATION IS SUBJECT
TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
NOTE:
THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS B DIGITAL
DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE
PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT GENERATES,
USES AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF NOT INSTALLED AND USED IN ACCORDANCE WITH
THE INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS. HOWEVER, THERE IS NO
GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A PARTICULAR INSTALLATION. IF THIS EQUIPMENT DOES
CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING
THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGE TO TRY TO CORRECT THE INTERFERENCE BY ONE OR
MORE OF THE FOLLOWING MEASURES:
• REORIENT OR RELOCATE THE RECEIVING ANTENNA
• INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER
• CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER
IS CONNECTED
• CONSULT YOUR LOCAL DEALER OR AN EXPERIENCED RADIO/TV TECHNICIAN FOR HELP.
6.6.1 Setting Remote Control Transmitter Codes
The opener can only operated from 4-button remote control
transmitters that have been programmed into its memory. Up to
64 codes can be stored in the memory.
a. Press the MODE button repetitively until the TRANSMIT
LED is lit.
b. Press and HOLD the button/s indicated in the
Fig 6.6.1
to set
the required transmitter function. The Main light will start to
flash rapidly.
c. Press one of the four (4) buttons on the remote control
transmitter
(Fig 6.6.2)
until the main light starts to flash
rapidly, then release transmitter button.
d. Press the remote control transmitter button again until the
main light stops flashing rapidly.
e. Release both buttons. The remote control transmitter button
is now coded, press to test.
NOTE: Refer to the Light indicator table for the details of the
transmitter status.
BUTTON
TRANSMITTER
FUNCTION
Open / Stop / Close
HOLD
PET (Pedestrian) Mode
HOLD
Open
HOLD
Light
HOLD
HOLD
Vacation Mode
HOLD
HOLD
MAIN LIGHT
TRANSMITTER
STATUS
ON
Button added
OFF
Button removed
2 FLASHES, then OFF
Remote control deleted
4 FLASHES, then OFF
Memory full
Fig.6.6.2
Button 1
Button 2
Button 3
Button 4
