Autocruise 2012 Van Conversion Range, Руководство пользователя

Страница: 71 / 153

equipment det
ails
69
truma ultrastore water heater
NOTICE: In the interest of safety,
replacement parts for an appliance shall
conform to the appliance manufacturer’s
specifications and should be fitted by them
or their authorised agent.
TRUMA ULTRA-SToRE
WATER HEATER
The water heater features a system that
will heat water using liquid petroleum gas
or 230V mains electricity. The heater can
be simultaneously operated on gas and
electricity to give a faster warm-up period.
The cassette has a capacity of 10 Iitres.
Attention: Always fit the cowl cap when
the water heater is not being operated!
Drain the water heater if there is risk of
frost and preferably when you leave the
site. Leave all taps open. Frost damage
is not covered by the warranty!
Filling the Truma-Ultrastore with water
1. Check that the safety/drain valve in the
cold water intake is closed. Lever should
be in horizontal position, position (e) Fig.
1.
Fig. 1
e = Lever position
‘Closed’
f = Lever position
‘Drain’
2. Open hot tap in bathroom or kitchen; set
pre-selecting mixing taps or single lever
fittings to ‘hot’.
3. Switch on power for water pump. Leave
the tap open to let air escape while the
water heater is filling. The heater is full
when water flows freely from the tap.
note: If only the cold water system is being
used, the heater tank will also fill with
water. In order to avoid damage through
frost, the water heater must be drained as
detailed in the following paragraph.
Draining the water heater
WARnInG: The water may be hot and
cause scalding.
1. Disconnect the water pump and switch off
power supply where appropriate.
2. Open all hot and cold water taps.
3. Open safety/drain valve and leave in
vertical position, position (f).
4. The water heater will drain directly to the
outside. Check that the water contents
have been completely drained (10 litres).
GAS oPERATInG InSTRUCTIonS
Attention: Do not operate the water
heater without water in it!
Remove the cowl cover prior to using the
water heater.
Switching on:
1. Remove cowl cover.
2. Open gas cylinder and open quick-acting
valve in the gas supply line.
3. Select required water temperature with
the inner rotary knob (b) (infinitely variable
from approx. 30ºC to 70ºC).
4. Switch on water heater by turning outer
rotary control (a) to the flame symbol. A
green indicator light will illuminate.
Fig. 2