19
3.2.5 REGISTER REMOTE CONSOLES TO THE BASE STATIONS
Each console must be registered separately.
1. Turn off all consoles.
3. Unscrew and remove the cover from the
master
base station.
4. Press the
Power button to turn on the remote console.
The screen will tell you to “Press the register switch on the
master base station”. NB. On first use AA570 will be on already.
5. Press and release the registration button. The green LED
will stay on. The red LED will flash to indicate the connection
is registering.
6. Registration is automatic. The screen will show that
the system is getting the network information and then
that the console has been successfully registered to the
base station. This could take up to 30 seconds.
7. Press the Mode button to select OK. The console
will return to the set up screen ready to set up the
system functions.
8. If you have more than 1 console to register to the
base station repeat the steps above ensuring the
first console is turned of
f before you start.
9. When finished replace the lid on the base station.
3.2.6 TO TURN THE AA570 REMOTE CONSOLE OFF AFTER REGISTRATION
Press the
to escape from Setup to
the default start up screen.
3.2.4 TURN THE AA710 SySTEM ON FOR THE FIRST TIME
Ensure the AA702 base station is powered up.
Press the Power button on the AA570
console to turn it on. Because the system
is not yet set up, the screen will tell you to press
the registration switch on the master base station.
See instructions below to register the console to
to the base station.
Power
Press and hold the Power button for 2 seconds
to switch off.
2. Connect the power to all base stations.
