7
Authorization by the PIN-code
Initial setting of the PIN-code is implemented when
turning on the two-step authentication mode (see
page 12). In order to disarm the system only by use
of the PIN-code (without key fobs or smartphones),
the two-step authentication mode should be turned
off (see page 14).
Sit at the steering wheel, turn on the ignition or start
the engine (in the case it is required) and enter the valid
PIN-code using the service/valet button of the car.
Entering of the PIN-code is recommended right before
driving. The time gap between the service/valet button
pushes should not exceed two seconds (there is no
difference between «long» and «short» pushes).
Entering of the correct PIN-code will be confirmed by
two indication signals (light or sound) and driving may
be started.
In the case the PIN-code has been entered incorrectly,
no signals will be provided and the engine will be
blocked at the attempt of driving. The second attempt
to enter the PIN-code is available immediately after the
failed one.
Two-step authorization (authentication) mode
Two-step authorization (authentication) in the KVANT
system is used for providing maximal safety and
protection to the car. When this mode is used, the
engine may be started only when both of the conditions
listed below have been abided:
!
Содержание Kvant 231
