19
valet button three times. The LED or the buzzer
indication will confirm successful undergoing of
the procedure with three signals.
The key fobs or the smartphone should be kept as
close as possible to the device. The coverage zone
is limited (recommended distance up to one meter).
3. Insert the battery into the new key fob. The LED on
key fob will start flashing continuously with green.
After successful connection the LED will blink once
with red light. If connection has not been successful,
the green light blinking will stops in 30 seconds
after inserting the battery.
4. Switch OFF the ignition.
5. Reset the KVANT system by disconnecting and
connecting again to the +12V power supply
(disconnect the car battery terminals). Check
out workability of the key fob after having been
connected to the device.
Manual connection
This method works for the key fobs which have
already been connected and then disconnected
from some immobilizer produced by Author-Alarm.
The key fobs with indication M52L on the print
should only be used. Do not use the older versions
of the key fobs with indication M24 on the print.
1. Switch on the key fobs connection mode as indicated
in passage 2 on page 18.
2. Close the contacts on the key fob (with a piece of
aluminum foil or a piece some other material that
!
!
!
Содержание Kvant 231
