45
Do not apply high-pressure water jets and avoid water leaking into the MaxiCharger.
Make sure that the inside of the MaxiCharger is dry during cleaning.
Do not use caustic solvents, sprays, solvents or abrasives. Use cleaning agents
with a pH between 6 and 8 for strong stains only.
Cleaning and Replacing the Filter
WARNING
Before cleaning, stop any charging processes and do not connect the power to the
MaxiCharger. Failure to do so may cause damage and/or personal injury or death.
Do not apply high-pressure water jets and avoid water leaking into the MaxiCharger.
Make sure that the inside of the MaxiCharger is dry during cleaning.
Do not use caustic solvents, sprays, solvents or abrasives.
The MaxiCharger is equipped with a filter with a large mesh area to prevent the electronic
components from being damaged by dust. Clean the filter every 3 months (not to exceed
6 months). Replace the filter annually.
To clean or replace the filter
1.
Before cleaning and replacing, be sure to stop all charging processes,
disconnect the external power supply, and perform the power-off protection.
2.
Open the two toggle latches (A) at the bottom of the MaxiCharger to flip the
bezel (B) downward.
3.
Remove the filter (C).
4.
Clean debris or dust of the filter and reinstall a cleaned filter. Alternatively
install a new air filter.
5.
Flip the bezel (B) upwards and close the two toggle latches (A).
