AUTEC C26PRO SERIES, Руководство пользователя

Страница: 12 / 22

- 8 - LIPROMA3-00
- 9 Transmitting un
it and how
it w
orks -
RPM +/- This selector works in two ways:
1. during normal operation: increases (rpm +) or decreases (rpm -) the
machine motor turns
2. during the set-up phase REMOTE SET UP: see chapter 12
Speed
selector A speed selector may be present, which makes the machine operate at different
speeds as necessary. This selector can have two, three or four positions which respec-
tively activate two, three or four speed levels.
Frequency
change In case of interference or conflict with other radio systems, it is possible to change
the radio frequency being used.
With the transmitting unit powered and started, keep the START pushbutton pressed
for 5-6 seconds: a prolonged beep accompanied by the switching on of both signalling
lLEDs indicate that the frequency has changed. During this operation the receiving
unit switches off: press the START pushbutton again to start working normally.
LED
signals
Some transmitting unit operating conditions are signalled by two signalling LEDs (one
green and one red):
When the battery is approximately 90% discharged, the green light will start flashing
at a faster rate to inform the operator that the battery requires recharging. If the op-
erator continues to use the radio control, approximately 3 minutes before the battery
is fully discharged, the red light will start flashing and an acoustic alarm will sound.
In this situation, the operator must return the machine to a condition of safety (by
pressing the stop pushbutton), switch off the transmitting unit, and recharge the bat-
tery or fit a fully charged battery.
Power off
Turn the ignition key to “O”.
Always remember to remove the starting keyswitch and put it in a safe place.
Automatic
power off The transmitting unit can switch off automatically when:
-
the battery is not sufficiently charged and/or
- the radio remote control has not been used for 3 and a half minutes (to deacti-
vate automatic switching off, please contact Autec authorized personnel).
Recharging
the battery Remove the battery from the transmitting unit and insert in the battery charger.
The “ON CHARGING” light will illuminate to indicate that the battery is being charged.
Once the battery is fully charged, the “END OF CHARGE” light will illuminate. Battery
charging should be performed at an ambient temperature within the range +5°C to
+45°C.
See the supplied manual for all instructions, warnings and technical
data regarding the batteries and the battery changer.
Signal type
LED
green red
Slow blinking normal operation /
Quick
blinking
Warning
that the battery is
almost discharged
Warning
that the battery is
discharged
Continuous light
on starting *
/
Command operated
during start up
Both LEDs steadily lit
simultaneously
Frequency change occurred
* accompanied by an acoustic signal