Aussie Bonza Deluxe Series, Руководство пользователя

Страница: 23 / 35

· Never connect or disconnect LP gas cylinder or fittings
while grill is in use or is hot.
· When the LP gas cylinder is connected, the grill must
be kept outside in a well-ventilated space. Turn off all
of the grill control knobs and the LP cylinder valve
when grill is not in use.
· Move gas hose as far away as possible from hot surfaces.
How to Connect your LP gas cylinder (See STEP 12 of Assembly
Instructions for diagram)
1) Make sure all of the control panel knobs are turned to the
“off” position and verify that the LP gas cylinder valve is
closed by turning the handle on the LP gas cylinder
valve clockwise until it stops.
2) Remove the protective cap from the LP cylinder gas
nozzle.
3) Hold regulator in a straight line with LP cylinder gas
nozzle so the connection does not cross thread.
4) Insert nipple into the LP cylinder nozzle opening.
5) Hand tighten coupling nut in a clockwise direction.
Do not use tools.
6) Perform a Leak Test. (See STEP 13 of Assembly
Instructions for Leak Test Instructions)
How to Disconnect your LP gas cylinder
1) Turn all control knobs to the “off” position and turn the
handle on the LP gas cylinder clockwise until it stops.
2) Turn coupling nut on regulator in a counter-clockwise
direction until regulator is released from threaded LP
cylinder gas nozzle.
3) Place the protective cap over LP cylinder gas nozzle.
BEFORE USING YOUR
LP GAS GRILL
· Do not use an LP gas grill indoors, on recreational
vehicles, or on a boat.
· This LP gas grill is for outdoor use only and should be
placed on firm, level surface. The grill should be setup in
an open area with good ventilation, away from high traffic
areas and combustible materials.
· Combustible or flammable materials should never be
used or stored within 36 inches of the back or sides of
your LP gas grill.
· Locate your LP gas grill at least 10 feet away from your
house or any building. Do not use the grill in a garage,
breezeway, carport, porch, or under a surface that can
catch fire.
· When moving or lifting your Aussie LP gas grill, its
recommended that you grasp the cross supports under
the side tables. Do not lift the grill with only the individual
side table slats.
· When moving your gas grill, you should push the grill in
front of you with the large wheels in the front.
· Carefully read the Important Safeguards
section of this manual (pages 2 thru 4). Make
sure you follow and understand all instructions
and
warnings. If you have any questions
regarding these pages, call 1-800-251-7558 and
· This installation must conform with local codes
or, in the absence of local codes, with either the
National Fuel Gas Code, ANSI Z223.1, or CAN/CGA-
B149.2, Propane Installation Code.
· If an external electrical source is utilized, the
outdoor cooking appliance, when installed, must be
electrically grounded in accordance with local
codes or, in the absence of local codes, with the
National Electrical Codes, ANSI/NFPA 70, or the
Canadian Electrical Code, CSA C22.1.
· If any electric appliance or rotisserie is used with
the LP gas grill, do not allow cords to touch or be near
hot
surfaces. Electric cords should be placed away from
walkways to avoid a tripping hazard.
· Grill storage cover must be removed and placed
at least 36 inches from the LP gas grill while in use.
The grill cover is made of a flammable material. The
grill must be completely cooled before putting the
cover back on the grill.
· Never store a spare or disconnected LP gas
cylinder under or near this LP gas grill.
· Inspect the hose and regulator assembly before
each use. If the hose is cut or damaged or shows
signs of excessive abrasion or wear, do not use the
LP gas grill. Contact the manufacturer, as the hose
must be replaced with an assembly specified by the
manufacturer prior to the further use of the LP
gas grill.
· Use only the hose and regulator assembly that
is supplied with your LP gas grill.
· Use of this LP gas grill other than for the
intended use, or alteration of the LP gas grill in any
way may not be safe and will void any warranty.
· LP gas is not natural gas. The conversion or
attempted use of natural gas in an LP unit is
dangerous and will void your warranty.
· Never use an LP gas cylinder if it shows
signs of: dents, gouges, bulges, fire damage,
corrosion, leak age, excessive rust, or other forms of
visual external damage; it may be hazardous and
should be checked by a Liquefied Petroleum supplier.
Do not use an LP cylinder with a damaged valve.
Selecting a Location
Precautions
23