Aurora Archer IS720G, Инструкция по установке и эксплуатации, Страница: 29 / 51

The 3-speed main convection fan will cut in automatically approximately 3 to 5 minutes after the
heater has warmed up. Note: The 3-speed main convection fan is automatically
controlled and will operate on three preset speeds. Depending on your heat setting and the surround-
ing ambient temperature.
The main convection fan will automatically adjust its speed in line with your heat setting.
On changing your heat setting there will be a delay on the operating speed of the fan until the firebox
has reduced sufficient temperature for the fan to change speed.
FAN OPERATION
HEATER SHUT DOWN
Note: The main convection fan in the heater will be operating on and off for up to approxi-
mately 45 minutes or more. intermittently until the firebox has been cooled down sufficiently
for the main fan to stop operating.
WARNING: DO NOT CUT MAIN ELECTRICAL SUPPLY TO THE HEATER AFTER THE
HEATER HAS BEEN SWITCHED OFF TO STOP MAIN FAN OPERARTING. THIS WILL
CAUSE AN OVERHEATING SITUATION IN THE HEAT EXCHANGER
RESULTING IN
DAMAGE TO THE PLASTIC COMPONENTS USED. THE MAIN FAN WILL STOP
OPERATING AUTOMATICALLY AFTER THE HEATER HAS COOLED DOWN .
Note: The time, date and room temperature will still be displayed on the remote display, but only
weekly program-settings will be changeable.
Turning the Fireplace Off - Remote
When operating the fireplace using the remote, the fireplace can be shut down by
turning the thermostat temperature down (when in thermostatic mode) or by pressing the power
button on the re- mote. When the temperature setting is adjusted to turn off the fireplace, the flame
level will be gradually adjusted down until the fireplace turns off. When the remote power button is
used, a single push will place the fireplace into Standby Mode and the remote will display the
“PILOT” symbol.
Holding down the power button until the backlight turns off will also turn off the remote and the fireplace.
The burner will instantly go off, but the circulating fan will continue to operate until the fireplace
cools off. To turn the remote and fireplace back on, hold the power button down until the remote’s
display panel backlight turns on again.
Turning the Fireplace Off - Display Panel
To turn the fireplace off from the display panel, press the “Mode Select” button on the fireplace dis-
play panel until the panel turns.
28