Aurora Archer IS720G, Инструкция по установке и эксплуатации, Страница: 23 / 51

22
Bottom
Note: It is easier to fit the surround on the heater if it is protruding from the wall by approximately 100mm then
push the heater back into place.
Note: Assemble the four piece’s of the surround together first excluding the bottom door flap before fitting it to
heater.
Note: when fitting side
panels, keep them to the
outside as much as
possible.
Hang hook tabs over the lip on
the top panel on the top front
section of the heater
Once the surround is hung on
the heater, then line up holes in
both side panels and fit the
8Gx12mm screws in place to
hold the surround in place.
Fit 8Gx12mm Button
self tapping screw.
Once the surround is screwed in position, then fit the
bottom door flap, fit the right hand side with the door
stop tab first, then line up left plunger and place in
position with receiver.
Fit 8Gx12mm Button
self tapping screw.
Plunges
Fit 2x M5x8+M5 Nut
Bottom Door Flap
Door Stop Tab
Plunger Receiver's
Hook Tabs
Fit 2x M5x8+M5
Nut
Right side panel
Fit 2x M5x8+M5 Nut
— — — — —
— — — —
— — — — —
— — — — —
— —
Top
Fit 2x M5x8+M5 Nut
ASSEMBLY AND FITTING OF BOLTED SURROUND FOR IS 720
INSTALLATION INSTRUCTIONS
Left side panel