NOTE:
If the wall is wooden,
there is no need to use wall
plugs. In such a case, drill two
holes 2.7 mm in diameter
instead of 5 mm, and screw the
screws directly into the wood.
NOTE:
The RTH receiver
cannot be placed in metal
containers
(e.g. an assembly
box, a metal enclosure of
a heater)
in order to not to
interfere with its operation.
OFF
ON
IN
OUT
ALARM
RESET
hole for fastening
the receiver to the
wall with a screw
16
hole for fastening
the receiver to the
wall with a screw
Pairing the wireless temperature regulator
with the RTH receiver
NOTE:
The wireless temperature regulator sold with the receiver is
already paired.
Devices sold separately require “pairing”.
17
3
. A properly completed pairing process is signalled by the LED on the receiver
no longer flashing green and the receiver reverting back to normal
operation.
In the event of an error during the pairing process, repeat steps 1 and 2.
Should more errors occur, deregister all devices by executing the RESET
function of the receiver (see “RESET - Deregistering all devices paired with
the receiver”) and attempt to pair the device again.
NOTE:
One receiver can have only one temperature regulator assigned.
1
. The
process of pairing
the regulator with the
receiver is initiated by pressing the left
pairing button (marked with a green triangle
- ) on the receiver and holding it for at least
2 seconds, until the LED starts flashing
green, and then releasing the button.
The AURATON RTH receiver waits for pairing
for 120 seconds. After that time, it
automatically returns back to normal
operation.
2
.
transmission symbol ( ) appears on the display. Release the button - the
regulator transmits the pairing signal for 5 seconds.
On the regulator, press the
button and hold it for 5 seconds until the
{prog}
{}
LED
