18
Deregistering the regulator from the receiver
1
.
Deregistering
the temperature controller from
the receiver is initiated by pressing the right
deregistering button (marked with a red
triangle - ) on the receiver and holding it for at
least 2 seconds, until the LED starts flashing
red, and then releasing the button.
The AURATON RTH receiver waits for
deregistering for 120 seconds. After that time,
it automatically returns back to normal
operation.
LED
3
. A properly completed deregistering process is signalled by the LED on the
receiver no longer flashing red and the receiver reverting back to normal
operation.
In the event of an error during the deregistering process, repeat steps
1 and 2. Should more errors occur, deregister all paired devices (see “RESET -
Deregistering all devices paired with the receiver”) and attempt to pair the
device again.
2
.
transmission symbol ( ) appears on the display. Release the button - the
regulator transmits the pairing signal for 5 seconds.
On the regulator, press the
button and hold it for 5 seconds until the
[prog]
19
RESET - Deregistering all devices paired with
the receiver
In order to deregister all devices paired with the
receiver, simultaneously press both the pairing
and the deregistering button ( and ) and hold
them for at least 5 seconds until the LED flashes
alternating red and green. Then release both
buttons.
A properly completed process of
deregistering all devices is signalled after
approx. 2 seconds by the LED colour
changing to green and then switching it off
for a short period of time.
LED
NOTE
: If after executing the RESET function the RTH receiver is disconnected
from power supply and then connected again, the receiver will automatically
enter “pairing” mode for 120 seconds. A newly purchased RTH receiver
without any factory-paired devices (i.e. not the one bundled with the
regulator) will behave the same way.
Signalling operation and reception of data packet
Each radio transmission received by the AURATON RTH receiver from the
paired device is signalled by a temporary change of LED colour to orange.
Switching on the relay is signalled by the LED lit red, whereas switching it off is
signalled by the LED lit green.
