Auping AVS 455, Руководство пользователя

Страница: 22 / 114

■ Only place the bed in a dry room.
Because of the electrical components
it is not permitted to place the bed in
a damp room.
■
Check if the input voltage indicated
on the transformer is the same as
the main voltage in the house.
■
Damaged power supply cables
should be replaced solely by the
manu facturer, its service division or
a similarly qualified person, to
prevent any risks.
■ Make sure that the cables cannot
become trapped. Check this by
adjusting the bed after it has been
installed.
■ Adjustable beds have moving parts.
Make sure that your limbs cannot
become trapped.
■ Release the controls immediately in
case anything becomes trapped in
between the moving parts. The
motors do not stop automatically
and continue to operate.
■
Only adjust the bed while you are
lying on it. Make sure that no children
are under the bed while it is being
adjusted.
■ Please do not sit on the head
support or foot end of the bed whilst
raised.
■ The AVS mesh base is not intended
for use by persons (including
children) with reduced physical,
sensory of mental capabilities, or
lack of experience and knowledge,
unless they have been given
supervision or instruction concerning
the use of the appliance by a person
responsible for their safety.
■
Always place the remote control
back in its RC-clamp on the AVS
frame at the bedside. Do not leave it
in your bed to avoid falling asleep on
it.
■ Disconnect the bed from the power
supply before cleaning. Pull the plug
out of the socket.
■ Remove the plug from the socket
during a thunderstorm.
■
Ensure that when you use an
extension cable, its power is higher
or equal to that mentioned on the
transformer. Use an approved
extension cable.
GB20