While an electrical fault may be a nuisance, it is never dangerous. All motors and
controls are fitted with all necessary safety devices and have double insulation.
The table below gives possible solutions to malfunctions.
If you have any doubts contact your dealer.
5. Breakdowns
GB27
Cause
Search
Solution
Undesirable noises (bed
squeaks and creaks)
Caused by moving parts
touching each other.
Apply Teflon spray.
Do not use oil.
Undesirable noises (bed
squeaks and creaks)
The box spring is not
leveled because the floor
is not absolutely flat.
Make sure the floor is
absolutely leveled.
Undesirable noises (bed
squeaks and creaks)
The reason for this may
be a missing part, or
parts that have not been
tightened properly or
have become loose when
the bed was moved.
Tighten parts.
Undesirable noises (bed
squeaks and creaks)
The bed is not positioned
away from the wall.
Position the bed away
from the wall.
Undesirable noises (bed
squeaks and creaks)
There are unwanted
objects in the bed that
should not be there
(spoons, forks, pens,
etc.).
Remove those objects.
Sparks fly when the
box spring control
system is being
plugged into the
transformer
The plug is already in
the wall socket before
the box spring control
system is connected.
First connect the box
spring control system,
then put the plug into
the socket.
Motor runs for a while
then stops
Faulty Hall sensor in
motor.
Set bed in horizontal
mode by alternately
adjusting up and down a
little at a time. Replace
motor.
Strange occurrences.
Motor does not adjust,
or only partially, etc.
Processor malfunction.
Reset. Unplug the bed,
wait a short while then
plug back in.
Wrong motor engages
Wrongly installed.
Install according to
fitting chart.
Nothing works
The plug is not in the
socket.
Put the plug into the
socket.
Содержание AVS 455
