2.
Refer to table and check if swing angle of the actuator corresponds to the setting
of the reduction gearing (stages 1– 9).
If the setting is not correct: continue with step 4.
If the setting is correct: continue with step 7.
Table 26:
Actuator swing angle and suitable reduction gearing setting
SQV 14.2
SQV 12.2
SQV 10.2
SQV 05.2 / SQV 07.2
4
3
2
2
30° +/–15°
5
4
3
3
60° +/–15°
6
4
3
3
90° +/–15°
6
5
4
3
120° +/–15°
6
5
4
4
150° +/–15°
7
5
4
4
180° +/–15°
7
6
5
4
210° +/–15°
7
6
5
5
290° +/–70°
3.
Loosen screw [1].
4.
Set crown wheel [2] to desired stage according to table.
5.
Tighten screw [1].
6.
Place indicator disc on shaft.
7.
Set mechanical position indicator.
Figure 91: Control unit with reduction gearing
[1]
Screw
[2]
Crown wheel
76
SQVEx 05.2 – SQVEx 14.2/ SQRVEx 05.2 – SQRVEx 14.2 Control unit: electronic (MWG)
Commissioning (settings in the actuator)
ACVExC 01.2 Modbus RTU
