3 of 20
ARMING THE SYSTEM (CHANNEL 1) : ACTIVE
1. Turn off the engine, exit the vehicle, and close and lock all doors, hood, and trunk.
2. Press and release the ARMING button on the keychain transmitter. The siren
will "chirp" once, the vehicle's parking lights will flash once, the doors will lock
(optional), and the dash mounted L.E.D. will begin to slowly flash.
WARNING!
Excessive pressure on the transmitter buttons will damage the internal
components on the circuit board. All that is required is a light push to the button.
NOTE:
If the siren "chirped" three times when ARMING, then one of the entry points
(hood, trunk, doors) has been left opened. Closing the hood, trunk, or doors will
correct the problem, and you do not need to disarm the system to make the
correction.
Page 2
1. Opening any door, hood or trunk will cause the alarm to immediately sound. The
siren will continue to sound for 30 seconds, then stop and automatically re-arm
the vehicle. If the potential thief left a door opened, the siren will sound for six
30 second cycles, then re-arm and ignore the opened door.
2. Whenever the system is armed, the Red dash mounted L.E.D. indicator will slowly
flash. This serves as a visual deterrent to the potential thief. The L.E.D. is a very
low current bulb, and will not cause the vehicle's battery to drain, even when left
unattended for extended periods.
3. Whenever the system is triggered, the vehicle's parking lights will flash for the
30 second alarm cycle, attracting added visual attention to the vehicle.
4. Whenever the system is armed, the vehicle's starter will be bypassed. If a thief
should choose to ignore the siren, the vehicle can not be started.
PROTECTION WHILE THE SYSTEM IS ARMED:
1. Turn off the engine, exit the vehicle, and close and lock all doors, hood, and trunk.
2. The dash mounted L.E.D. will begin to flash rapidly, indicating that the system
is automatically (passive) arming. As an added convenience, the automatic
passive arming will not begin until all doors and trunk lid are closed, allowing
passengers to exit the vehicle at their convenience.
3. In 30 seconds, you will hear a single short "chirp" from the siren, and the vehicle's
parking lamps will flash one time, indicating the system is ARMED. At this time,
the dash mounted L.E.D. will begin to flash slowly, providing a visual indication
that the system is fully ARMED.
OPTION NOTE: If the optional (not included) power door lock interface has
been installed, the alarm control module can be programmed to...
a) Automatically lock the doors during step 3 above or,
b) Only lock the doors when step 4 below is executed.
4.
If you wish to arm the system immediately, simply press and release the
ARMING button on the keychain transmitter. The siren will "chirp" once, the
vehicle's parking lamps will flash once, the doors will lock (optional), and the dash
mounted L.E.D. will begin to slowly flash.
ARMING THE SYSTEM (CHANNEL 1) : PASSIVE
