32
ACO platform features
Beside the unique DSP sound effects the UP 8DSP
provides a bunch of new system features.
In the DCM menu of the DSP PC-Tool software in-
dividual settings can be made for several of these
system features.
Turn On & Off Delay
This function allows to determine the delay time
with which the integrated DSP is switched on and
off. The factory setting is 0.2 seconds. The delay
time should only be modified if there are e.g. noises
while switching on / off the amplifier.
URC Setup Switch Configuration
The ACO provides ten internal memory locations for
sound setups instead of the common two.
By using an optional URC remote control or the
Control pushbutton
(see page 20) it is possible to
toggle between two of the ten memory locations.
These two memory locations can be determined in
the “URC Setup Switch Configuration”. The memory
locations one and two are preassigned by default.
To switch between all internal memory locations, the
optionally available remote controls DIRECTOR and
CONDUCTOR are recommended.
Remote Output Configuration
This function controls if the remote output (which
switches on and off the connected amplifiers) will
be temporarily deactivated during a sound setup
switch. This function is activated (ON) by default.
ADEP.3 Configuration
If the UP 8DSP is connected to an OEM radio via
the highlevel inputs it may happen that the ADEP.3
circuit has to be adapted to the diagnostic mode of
the radio if the latter is equipped with a so-called
“class SB” output stage.
In the “ADEP.3 SB compatibility mode & Advanced
Noise Suppression” section, an adjustment should
be made if there are e.g. distortions occur in the
upper volume range.
The compatibility mode is enabled by default.
