27
en
Additional functions
1. Status LED
The
Status LED
indicates the operating mode
of the amplifier and of the DSP memory.
Green:
Amplifier is ready for operation.
Orange:
Power Save Mode is activated.
Red:
Protection Mode is active. This may have
different root causes. The amplifier is equipped
with protection circuits against over- and under-
voltage as well as overheating. Please check
for connecting failures such as short-circuits or
other wrong connections.
If the amplifier is overheated the internal tem
-
perature protection switches off the remote and
signal output until it reaches a safe temperature
level again.
Red
/
green
slow flashing:
No operating soft-
ware installed. Connect the amplifier to the DSP
PC-Tool software and confirm the automatic up
-
date of the operating system. You will find the
latest version of the DSP PC-Tool software at
www.audiotec-fischer.com.
Red
/
green
fast flashing:
The currently selected
sound setup memory is empty. A new setup has
to be loaded via the DSP PC-Tool software or
switch to a memory position with existing sound
setup.
2. Control pushbutton
The UP 8DSP provides 10 internal memory
locations for sound setups. The
Control push-
button
allows the user to switch between two
memory positions. These can be defined in the
DSP PC-Tool. In addition a device reset can be
made by pressing the button for a longer period.
1. Setup switch: Press
Control pushbutton
for
1 second. The memory locations one and two
are defined by default. Switching is indicated
by a single red flash of the
Status LED
. Alter-
natively, the optional URC.3 remote control can
be used for switching. To switch between all in-
ternal memory locations, optional accessories
like the DIRECTOR display remote control or
CONDUCTOR are required.
2. Device reset:
Press pushbutton for five sec
-
onds. This completely erases the internal mem-
ory and is indicated by a continuous red glowing
and constant green flashing of the
Status LED
.
Attention:
After erasing the setups from mem-
ory the UP 8DSP will not reproduce any audio
output until the device is updated via the DSP
PC-Tool software.
3. SCP (Smart Control Port)
This multi-functional input is designed for
MATCH UP 8DSP accessory products like a
remote control which allows to adjust several
features of the amplifier. Depending on the type
of remote control, at first its functionality has to
be defined in the “ Device Configuration Menu”
of the DSP PC-Tool software.
Attention:
If the accessory product does
not have a NanoFit connector solely use the
NanoFit adaptor which is included in delivery
for connection.
NanoFit adaptor
