18
Connectors and control units
1
Auto Remote
This switch allows to activate / deactivate the
automatic turn-on feature of the amplifier
.
2
System Connector 2
Connector for loudspeakers and / or sub-
woofers.
3
Clipping LED
This LED lights up red if one of the analog
inputs is overdriven.
4
System Connector 1
Connector for the UP 7DSP cable harness.
Only use the supplied connection cable to
connect the amplifier to the car radio.
5
Fuse LED
This LED will light up if the fuses inside the
amplifier are blown.
6
+12 V
Connector for the +12 V power cable to the
positive terminal of the battery.
7
GND
Connector for the ground cable (negative
terminal of the battery or metal body of the
vehicle).
8
REM
Connector for the remote cable.
1
2
3
4
5 6 7 8
9
USB Input
Connects the UP 7DSP to your PC.
10
Control pushbutton
Use this button to either switch between the
setups or initiate a reset of the device.
11
Status LED
This LED indicates the operating mode of
the amplifier and the setup that has been
chosen.
12
Control Input
Multifunction interface for e.g. an optional
remote control or other MATCH UP 7DSP
accessory.
13
Optical Input
Optical input for digital stereo signals (SPDIF
format).
14
Gain
Control for adjusting the input sensitivity.
15
Remote Out
The remote output has to be used to turn on /
off external amplifiers that are connected to
the
Line Out
.
16
Line Out
Mono line output for connecting external am-
plifiers. Make sure that the remote output is
used to turn on these devices.
10 11
9
16
15
13
12
14
