31
Please use setup option 'Set Channel for By-Pass Mode' to select which of the
six input channels of the SAM G2 is fed through to the outputs if By-Pass
Mode is active.
Important
·
First, select the input channel used for By-Pass Mode (see section
'
Set Channel for By-Pass Mode
' on page 23), before you activate the
By-Pass Mode for the first time.
Activate the special function By-Pass Mode of your SAM G2 by pressing
the key
By-Pass Mode
of the Audionet System Remote Control. The
signal at the input channel selected for By-Pass Mode operations is
passed through the SAM G2 at a level of 0 dB (i.e. no change in volume
level) to the outputs.
Important
·
Please check the correct connection and setup before you use the
By-Pass Mode for the first time. The input signal will be passed
through to the outputs at full level!
As soon as the By-Pass Mode is activated, the SAM G2 will ignore all
control commands coming from the keys on the front panel or remote
control (exceptions see below)!
Important
There are only two possibilities to disable the By-Pass Mode:
1.
Press key
By-Pass Mode
of the Audionet System Remote Con-
trol. The SAM G2 switches back to the input channel selected before
resetting the volume to a safe level of -50 dB.
2.
Push the
power
key on the front panel or the keys
Power Toggle
or
Power Off
on the Audionet System Remote Control. The
SAM G2 switches off to stand-by mode.
Note
·
If you leave the By-Pass Mode by pushing the
power
key on the
front panel, this mode will
not
be saved, i.e. if you switch on the
SAM G2 again, the unit will switch to the last saved input channel se-
lection and not to the By-Pass Mode. If you would like to use the By-
Pass Mode again, press key
By-Pass Mode
of the Audionet Sys-
tem Remote Control
Harmony One
.
Содержание SAM G2
Страница 1: ...1 Stereo Amplifier User s Manual ...
Страница 2: ...2 ...
Страница 7: ...7 2 Overview front panel Display power key down key IR remote control receiver up key set key ...
