Audionet SAM G2, Руководство пользователя

Страница: 14 / 36

14
6 Usage
All functions of the SAM G2 are microprocessor controlled. This guaran-
tees highest precision, exclusive functions, easy handling and protection
against operating errors.
6.1 Powering up
First of all, please make sure your SAM G2 is connected correctly to your
signal sources and mains (see section '
Installation and power supply ' on
page 8 and ' Inputs and outputs ' on page 11).
The SAM G2 is a stand-by unit. Please operate the mains switch 10 on
the back panel. The display shows a welcome message for a brief mo-
ment. After that the SAM G2 is in stand-by mode.
Only in cases of extended absence (like vacations) or if massive trouble
on the mains power is to be expected (e.g. thunder storms) it is recom-
mended to disconnect the SAM G2 from the mains. While the SAM G2 is
in stand-by mode, operate mains switch 10 on the back panel. To dis-
connect the SAM G2 from mains completely, you have to pull the mains
cord off the mains jack 9 .
Important
·
Before you switch off the SAM G2 from mains, power down and
discharge completely all units connected to the outputs of the
SAM G2.
6.2 Switching on and off
To power up the SAM G2 from stand-by mode, press the
power
key on
the front panel. The SAM G2 displays the message
Waking up...
. In
case the mains plug has the incorrect polarization a warning will appear
in the display (see section '
Mains phase detection ' on page 15). After that
the unit is in normal operating mode and ready to use.
If you would like to switch off the unit, please press the
power
key on the
front panel. The display shows the message
Going to sleep..
and
unit enters the stand-by mode.
Note
·
Of course, you may switch on/off the SAM G2 with the Audionet
System Remote Control
Harmony One . For detailed information
please refer to section ' Screen 2 ' on page 29