Audionet AMP VII, Руководство пользователя, Страница: 15 / 27

15
6.4 Using Audionet Link
If your AMP VII is connected to an Audionet pre amplifier via 'Audionet
Link', use the remote control of the pre amplifier to automatically switch
on/off the AMP VII (and all other units connected via 'Audionet Link').
For setting up the necessary connections please refer to section ' Audionet
Link ' on page 12.
Note
·
Some Audionet units forward the 'switch on' signal over the Audionet
interface with a small delay to avoid all units switching on at the
same moment, which could cause an overload of your mains fuse.
Please consult the manual of your other Audionet units for further in-
formation.
·
Independently from the 'Audionet Link' interface, you can switch
on/off your AMP VII at any time using the
power key on the front
panel.
6.5 AutoStart function
If the AutoStart function is active, the AMP VII starts up automatically to
normal operating mode and does not stay in stand-by mode right after the
unit is connected to mains power (e.g. by operating the mains switch on
the bottom side). Use this option to start up the AMP VII automatically
using a timer device. For further details please refer to section '
Set
AutoStart ' on page 22.
6.6 Warm Up countdown
While you are absent the AMP VII can switch on automatically after a
preselected time (15 minutes up to 99 hours and 45 minutes) and is then
preheated and ready for a listening session when you get back.
To setup the countdown clock press the
power
key on the front panel
longer than 2 seconds (= long keystroke) while the AMP VII is in stand-
by mode. The display shows:
WARM UP IN :
01 hour 15 min
The cursor marks the digit of the countdown time to edit. A long key-
stroke moves the cursor one digit to the right.
Use short keystrokes (= press key less than 2 seconds) on the
power
key
to set the desired digit. Hours can be programmed in steps of 1 hour,